• Hi Guest - Sign up now for Secret Santa 2024!
    Click here to sign up!
  • Hi Guest - Come check out all of the new CP Merch Shop! Now you can support CigarPass buy purchasing hats, apparel, and more...
    Click here to visit! here...

Staebell controller and fan upgrade....it's....alive...!!

For simple, I'd rather see the float attach to the top and hang vertical. The bulkhead fitting could be a potential leak down the road unless it was always above the water level.

But if you're monitoring humidity, why sweat tank level? If humidity goes below your low threshold, you know to check the water.
IMG_20190220_110755.jpg
 
But if you're monitoring humidity, why sweat tank level? If humidity goes below your low threshold, you know to check the water.
...that's my take on it. When this is running properly (almost there), it's super consistent and if something changes a point or more, it's time to take a look....
 
For simple, I'd rather see the float attach to the top and hang vertical. The bulkhead fitting could be a potential leak down the road unless it was always above the water level.

But if you're monitoring humidity, why sweat tank level? If humidity goes below your low threshold, you know to check the water.
View attachment 25147

link magnetic bracket
 
I guess I could use two copper probes at different levels and just connect them to a continuity meter.

I use sterile water for irrigation which isn’t a great conductor, but it should be good enough; especially if I use colloidal silver.
 
Top