• Hi Guest - Come check out all of the new CP Merch Shop! Now you can support CigarPass buy purchasing hats, apparel, and more...
    Click here to visit! here...

Workshop Projects

This is our next project. Anything you would do differently?

So far I wouldn't do anything different.

I used 1/4" MDF for the panels, cut into 4 equal widths, my wall is 170" wide. My panels are about 42.5" wide and 72" tall. I used construction adhesive and nails to apply the MDF to the wall. The trim pieces are done the same way with construction adhesive and nails.

I was considering using 1/8" MDF, but the people at the molding place I go to said that 1/8" MDF would show imperfections in the wall a lot easier.

The LED strip I used is almost 1/4" wide, I adjusted the top trim piece up a touch so it created a raceway for the LED strip. The LED strip is wired to 3-way switches so it can be turned on and off from either side of the bed, and the transformer will be buried in the wall. I will take a picture of the raceway and add it to the above post.

This is the LED Strip I used.

The next step is to sand and fill all the holes and joints, then paint.

I'm also skimming the wall above the panels and going to do a metallic wallcovering that's a graphite color.
 
Top